LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System - 4.4L - DTC P0506 To P2544) >> DTC P0685, P0689, or P0690 >> Repair Procedures

Repair Procedures

WARNING: This page is about a different variant/trim than selected.

Always perform the Diagnostic Repair Verification after completing the repair.

  1. Refer to Control Module References for ECM replacement, setup, and programming.
  2. Clear the DTCs with a scan tool.
  3. Turn OFF the ignition for 30 seconds.
  4. Start the engine. If engine does not run, refer to Engine Cranks but Does Not Run .
  5. If other DTCs are set, refer to Diagnostic System Check - Vehicle .