Conditions for Setting the DTC

DTC P0133 or P0153

• The control module detects that the HO2S 1 rich-to-lean or lean-to-rich average response time is more than 0.14 second.
• These DTCs set within 60 seconds when the above condition is met.

DTC P0134 or P0154

• The control module detects that the HO2S 1 parameter is between 400-500 mV.
• The Throttle Position (TP) Indicated Angle parameter changes more than 5 percent.
• These DTCs set within 101 seconds when the above conditions are met.

DTC P0140 or P0160

• The control module detects that the HO2S 2 parameter is between 400-500 mV.
• The TP Indicated Angle parameter changes more than 5 percent 5 times.
• These DTCs set within 101 seconds when the above conditions are met.

DTC P1133 or P1153

• The control module detects that the HO2S 1 rich-to-lean counts, or the lean-to-rich counts are less than a calibrated value.
• These DTCs set within 60 seconds when the above condition is met.