Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0010, P0011, P0013, P0014, P0020, P0021, P0023, P0024, P0335, P0336, P0340, P0341, P0345, P0346, P0365, P0366, P0390, P0391, P2088, P2089, P2090, P2091, P2092, P2093, P2094, P2095 are not set.
The engine is running.
The calculated oil temperature is between -10°C to +150°C (+14°F to +302°F).
The oil pressure is greater than 105 kPa (15 psi).
The Low Oil Switch parameter is 0.
The battery voltage is between 11-16 volts.
The CMP actuator is commanded to the park position or to its full travel.
DTC P0016, P0017, P0018, or P0019 runs continuously when the above conditions are met.