LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System - 4.4L - DTC P0010 To P0175) >> DTC P0016, P0017, P0018, or P0019 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: If you cannot duplicate the condition, operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
  1. Operate the vehicle at idle and at various engine speeds and load ranges while observing the CMP Variance, Desired CMP, and CMP Angle parameters with a scan tool.
  2. All three parameters should remain less than or equal to 1 degree at idle. The CMP Variance should remain less than or equal to 1 degree unless the CMP actuator is being commanded. If the CMP actuator is moved, the CMP Variance will rise for 1-2 seconds until the CMP Angle parameter matches the Desired CMP parameter. The CMP Variance should again return to less than or equal to 1 degree.
    • If the CMP Variance remains more than 1 degree for more than 3 seconds, continue with the Circuit/System Testing.
scientia non olet · About LEMON Manuals