LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 4.4L (1 Of 5)) >> On-Vehicle Repair Instructions (Part 1) >> Engine Mount Bracket Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the right exhaust manifold.
  3. Install a screw jack with a block of wood under the oil pan for support.
    4. Fig 1: View Of Right Engine Mount - RWD
    GM888289Courtesy of GENERAL MOTORS CORP.
  4. Remove the right engine mount upper retaining nut.
    5. Fig 2: View Of Right Engine Mount Bracket - RWD
    GM888292Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure not to distort or bend the engine mount heat shield.
  5. Remove the right engine mount bracket mounting bolts.
  6. Remove the engine mount bracket from the vehicle.
scientia non olet · About LEMON Manuals