LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 4.4L (1 Of 5)) >> On-Vehicle Repair Instructions (Part 1) >> Engine Mount Bracket Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the left exhaust manifold.
  3. Install a screw jack with a block of wood under the oil pan for support.
    4. Fig 1: View Of Left Engine Mount
    GM888298Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper engine mount retaining nut.
    5. Fig 2: View Of Left Engine Mount Bracket
    GM888296Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure not to distort or bend the engine mount heat shield.
  5. Remove the left engine mount bracket retaining bolts.
  6. Remove the left engine mount bracket.
scientia non olet · About LEMON Manuals