Scan Tool Data List
The scan tool data lists contain all the instrument panel, gage, and console related parameters that are available on the scan tool. The parameters in the list are arranged in alphabetical order. The data list column indicates the location of the parameter within the scan tool menu selections.
Use the scan tool data lists as directed by a diagnostic table or in order to supplement the diagnostic procedures. Begin all of the diagnostic procedures with Diagnostic System Check - Vehicle in Vehicle DTC Information.
Use the scan tool data lists only after the following is determined:
- There is no published DTC procedure nor published symptom procedure for the customer concern.
- The DTC or symptom procedure indicated by the diagnostic system check does not resolve the customer concern.
The typical data values are obtained from a properly operating vehicle under the conditions specified in the first row of the scan tool data list table. Comparison of the parameter values from the suspect vehicle with the typical data values may reveal the source of the customer concern.
Engine Control Module (ECM) - 4.6L
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Engine Idling/Normal Operating Temperature | |||
| Cruise Control Active | IPC ECM Data | No / Yes | No |
| Commanded Gear | IPC ECM Data | Shift, 1st, 2nd, 3rd, 4th, 5th, Invalid, Reverse, Neutral, Park | Park |
| ECT Sensor | IPC ECM Data | °C (°F) | 85-105°C (85-220°F) |
| Engine Oil Life Remaining | IPC ECM Data | 100-0 Percent (%) | Varies w/oil life remaining |
| Engine Oil Pressure Sensor | IPC ECM Data | Volts | Varies w/oil pressure |
| Engine Oil Pressure Sensor | IPC ECM Data | kPa (psi) | Varies w/oil pressure |
| Engine Oil Temperature Calculated | IPC ECM Data | °C (°F) | Varies w/oil temperature |
| Engine Speed | IPC ECM Data | RPM | +/-100 RPM from Desired Idle Speed |
| Fuel Level Sensor - Left Tank | IPC ECM Data | Volts | Varies w/fuel level |
| Fuel Level Sensor - Right Tank | IPC ECM Data | Volts | Varies w/fuel level |
| Fuel Tank Level Remaining | IPC ECM Data | Liters (Gallon) | Varies w/fuel level |
| Ignition 1 Signal | IPC ECM Data | Volts | 9 - 16 Volts (varies) |
| Malfunction Indicator Lamp (MIL) Circuit Status | IPC ECM Data | Fault | Off |
| Malfunction Indicator Lamp (MIL) Command | IPC ECM Data | Off/On | Off |
| Vehicle Speed Sensor | IPC ECM Data | Kilometers per hour (Miles per hour) | 0 Km/h (0 mph) |
Engine Control Module (ECM) - 4.4L
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Engine Idling/Normal Operating Temperature | |||
| Change Engine Oil Indicator Command | IPC ECM Data | Off/On | Off |
| Cruise Control Active | IPC ECM Data | No/Yes | No |
| ECT Sensor | IPC ECM Data | °C (°F) | 85-105°C (85-220°F) |
| Engine Oil Level Switch | IPC ECM Data | Ok/Low | Ok |
| Engine Oil Life Remaining | IPC ECM Data | 100-0 Percent (%) | Varies w/oil life remaining |
| Engine Oil Pressure Sensor | IPC ECM Data | kPa (psi) | Varies w/oil pressure |
| Engine Oil Temperature Sensor | IPC ECM Data | °C (°F) | Varies w/oil temperature |
| Engine Oil Temperature Calculated | IPC ECM Data | °C (°F) | Varies w/oil temperature |
| Engine Speed | IPC ECM Data | RPM | +/-100 RPM from Desired Idle Speed |
| Fuel Level Sensor - Left Tank | IPC ECM Data | Volts | Varies w/fuel level |
| Fuel Level Sensor - Right Tank | IPC ECM Data | Volts | Varies w/fuel level |
| Fuel Tank Level Remaining | IPC ECM Data | 0 - 100 Percent (%) | Varies w/fuel level |
| Ignition 1 Signal | IPC ECM Data | Volts | 9 - 16 Volts (varies) |
| Ignition Accessory Voltage | IPC ECM Data | Off/On | Off |
| Low EOP Indicator Command | IPC ECM Data | Off/On | Off |
| Low Engine Oil Level Indicator Command | IPC ECM Data | Off/On | Off |
| Malfunction Indicator Lamp (MIL) Circuit Status | IPC ECM Data | Fault | Off |
| Malfunction Indicator Lamp (MIL) Command | IPC ECM Data | Off/On | Off |
| Vehicle Speed Circuit Status | IPC ECM Data | Short Gnd Open/Open/Short to B+/Incomplete/Ok | Ok |
| Vehicle Speed Sensor | IPC ECM Data | Kilometers per hour (Miles per hour) | 0 Km/h (0 mph) |
Engine Control Module (ECM) - 3.6L (LY7)
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Engine Idling/Normal Operating Temperature | |||
| Cruise Control Active | IPC ECM Data | No/Yes | No |
| Current Gear | IPC ECM Data | P/N, 1st, 2nd, 3rd, 4th, 5th, Reverse | P/N |
| ECT Sensor | IPC ECM Data | °C/°F | 85-105°C (85-220°F) |
| Engine Oil Level Switch | IPC ECM Data | OK/Low | OK |
| Engine Oil Life Remaining | IPC ECM Data | % | 0-100% Varies |
| Engine Oil Pressure Sensor | IPC ECM Data | OK / Low | OK |
| Engine Oil Pressure Sensor | IPC ECM Data | kPa (psi) | Varies w/oil pressure |
| Engine Speed | IPC ECM Data | RPM | +/-100 RPM from Desired Idle Speed |
| Fuel Level Sensor - Left Tank | IPC ECM Data | Volts | Varies w/fuel level |
| Fuel Level Sensor - Right Tank | IPC ECM Data | Volts | Varies w/fuel level |
| Fuel Tank Level Remaining | IPC ECM Data | Liters (Gallon) | Varies w/fuel level |
| Ignition 0 Signal | IPC ECM Data | Off/On | On |
| Ignition 1 Signal | IPC ECM Data | Off/On | On |
| Reduced Engine Power | IPC ECM Data | Inactive/Active | On |
| Vehicle Security Status | IPC ECM Data | Fuel Continued Disable Timeout Disable Ign. Off Key Timer Active VTD Fail Enable Learn Enable |
Fuel Continued |
| Vehicle Speed Sensor | IPC ECM Data | Kilometers per hour (Miles per hour) | 0 Km/h (0 mph) |
HUD
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF | |||
| Adjust Display Down Switch | IPC HUD Data | Inactive/Active | Inactive |
| Adjust Display Up Switch | IPC HUD Data | Inactive/Active | Inactive |
| Ambient Light Sensor | IPC HUD Data | - | - |
| Auto. Trans. Equipped | IPC HUD Data | No/Yes | No |
| Battery Voltage Signal | IPC HUD Data | Volts | 9-16 Volts (varies) |
| Display Dimming Signal | IPC HUD Data | Volts | Varies |
| Display Dimming | IPC HUD Data | % | 0-100% (varies) |
| English/Metric Status | IPC HUD Data | English/Metric | Metric |
| Ignition Cycle Counter | IPC HUD Data | Counts | Varies w/ignition cycles |
| Speed Biasing Status | IPC HUD Data | Disabled/Enabled | Disabled |
Instrument Panel Cluster (IPC)
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/Park Brake Unapplied | |||
| Battery Voltage Signal | IPC Data | Volts | 9-16 Volts |
| Brake Fluid | IPC Data | OK/Low | OK |
| Brake Fluid Switch | IPC Data | Volts | Varies w/fluid level |
| English/Metric Switch | IPC Data | Inactive/Active | Inactive |
| Engine Speed Signal | IPC Data | RPM | 0 RPM |
| Gage Backlight Dimming | IPC Data | % | Varies |
| Ignition 1 Input | IPC Data | Inactive/Active | Active |
| Ignition Cycle Counter | IPC Data | Counts | Varies |
| Indicator Dimming | IPC Data | % | Varies |
| Information Down Switch | IPC Data | Inactive/Active | Inactive |
| Information Reset Switch | IPC Data | Inactive/Active | Inactive |
| Information Up Switch | IPC Data | Inactive/Active | Inactive |
| LCD Dimming | IPC Data | % | Varies |
| Pointer Dimming | IPC Data | % | Varies |
| PRNDL State | IPC Data | Invalid, First Gear, Second Gear, Third Gear, Fourth Gear, Fifth Gear, Reverse, Neutral, Park, Drive, Not Available | Park |
| Trip Odometer A/B Switch | IPC Data | Inactive/Active | Inactive |
| Trip Reset Switch | IPC Data | Inactive/Active | Inactive |
| Vehicle Speed | IPC Data | km/h (mph) | km/h (mph) |