LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> STS Base, 3.6 7, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Driver Knee Bolster Bracket Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Knee Bolster Reinforcement
    GM1386652Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the bolts securing the bolster bracket to the instrument panel.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    2. Fig 2: View Of Bolster Trim Panel
    GM1386654Courtesy of GENERAL MOTORS CORP.
  2. Locate the bolster trim panel onto the Instrument panel.
  3. Push the trim panel in order to secure the clips to the instrument panel.
  4. Install the insulator to the instrument panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
scientia non olet · About LEMON Manuals