MPH (Km/h) Indicator Inoperative

Step	Action	Value	Yes	No
Schematic Reference: Instrument Cluster Schematics
1	Did you perform the Diagnostic System Check - Vehicle?	-	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Turn the ignition ON, with the engine OFF. Press and release the Eng/Met button. Does the MPH indicator and then the km/h indicator illuminate after each button activation?	-	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Install a scan tool. With a scan tool, observe the English/Metric Status parameter in the IPC data list. Press the Eng/Met button. Does the English/Metric Status parameter display Active?	-	Go to Step 4	Go to Step 5
4	Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you find and correct the condition?	-	Go to Step 5	-
5	Operate the system in order to verify the repair. Did you correct the condition?	-	System OK	Go to Step 2