LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade EXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1728 (Antilock Brake System - Non-Hybrid Greater Than/Equal To 3900 Kg (8600 Lb) GVW With TCS & VES) >> Diagnostic Information and Procedures >> DTC C0055 or P0609 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: A condition may result in a stored history DTC C0055, check the replicated transmission output speed signal circuit for damaged wires, missing pulses or electrical noise that may be passed to 128K pulses/mile engine speed signal.
  1. Verify that no DTCs are set in the ECM or TCM.
  2. Observe the scan tool Rear Wheel Speed parameter. The rear wheel speed reading should be within 2 mph of the front speed sensors when driving in a straight line at a speed greater than 20 km/h (13 mph).
    • If not within the specified range, refer to Circuit/System Testing.
  3. Operate the vehicle within the Conditions for Running the DTC, to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.