Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL and 2006 GMC Yukon. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Vehicle Speed Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the speed sensor with a NEW O-ring seal.
Tighten: Tighten the sensor to 17 N.m (13 lb ft).

Fig 2: View Of Speed Sensor & Encoder Motor Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the speed sensor electrical connector (1).
Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .