Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL and 2006 GMC Yukon. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Selector Switch From Housing

Courtesy of GENERAL MOTORS CORP.

Install the shift control switch to the housing.

Fig 2: Disconnecting Selector Switch Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Install the headlamp, shift control, and cargo lamp switch housing.
Connect the following electrical connectors:
- Cargo lamp switch (1)
- Shift control switch (2, 3)
- Headlamp switch (4)

Fig 3: View Of Air Deflector Louver, Retainers & Switches

Courtesy of GENERAL MOTORS CORP.

Push in the headlamp, shift control, and cargo lamp switches in order to engage the retainers.
Install the air deflector louver.
Install the I/P cluster bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster in Instrument Panel, Gages, and Console.