LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 793 (Transfer Case - BW 4482-Nr4 - Service) >> Repair Instructions >> Transfer Case Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL and 2006 GMC Yukon. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Transfer Case Shield & Bolts (2500 Series)
    GM396828Courtesy of GENERAL MOTORS CORP.
  1. If the vehicle is a 2500 series, position the transfer case shield, if equipped.
  2. Install the transfer case shield screws, if equipped.
    3. Fig 2: View Of Transfer Case Shield & Bolts
    GM826834Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. If the vehicle is a 1500 series, position the transfer case shield, if equipped.
  4. Install the transfer case shield bolts, if equipped.

    Tighten:  Tighten the bolts/screws to 20 N.m (15 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals