LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 793 (Transfer Case - BW 4482-Nr4 - Service) >> Repair Instructions >> Transfer Case Fluid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL and 2006 GMC Yukon. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When performing the following procedures, use only hand tools to remove and install the drain and fill plugs.
    Fig 1: View Of Transfer Case Plug
    GM819569Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  3. Remove the fill plug.
  4. Remove the drain plug.
  5. Allow the transfer case fluid to drain completely.
scientia non olet · About LEMON Manuals