LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 793 (Transfer Case - BW 4482-Nr4 - Service) >> Repair Instructions >> Transfer Case Encoder Motor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL and 2006 GMC Yukon. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Speed Sensor & Encoder Motor Electrical Connectors
    GM856630Courtesy of GENERAL MOTORS CORP.
  1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  2. Remove the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  3. Disconnect the encoder motor electrical connector (2).
    4. Fig 2: View Of Transfer Case Encoder Motor & Bolts
    GM819575Courtesy of GENERAL MOTORS CORP.
  4. Remove the encoder motor bolts.
  5. Remove the encoder motor.
scientia non olet · About LEMON Manuals