Conditions for Running the DTC

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

No MAF sensor DTC P0101, P0102 or P0103.
No MAP sensor DTC P0106, P0107, or P0108.
No TP sensor DTC P0120 or P0220.
No AT VSS DTC P0502 or P0503.
No AT ISS DTC P0716 or P0717.
No TCC Stuck ON DTC P0742.
No Shift Solenoid Electrical DTC P0753 or P0758.
No Transmission Component Slipping DTC P0894.
No TFP manual valve position switch DTC P1810.
No TCC PWM electrical DTC P2761.
Not in 4WD low.
The engine is running for greater than 7 seconds.
The transmission ISS is greater than 7 RPM.
The transmission OSS is greater than 7 RPM.
The system voltage is 10-18 volts for 0.5 second.
The throttle angle is greater than 10 percent.
The transmission fluid temperature (TFT) is greater than 20°C (68°F) and less than 130°C (266°F).
The engine torque must be between 108 N.m (80 lb ft) and:
- 6.0L: 542 N.m (400 lb ft)
- 8.1L: 881 N.m (650 lb ft)
The engine vacuum is 0-105 kPa.