Conditions for Running the DTC

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

No MAF DTC P0101, P0102 or P0103.
No MAP sensor DTC P0106, P0107, or P0108.
No TP sensor DTC P0121, P0122, or P0123.
No VSS DTC P0502 or P0503.
No ISS DTC P0716 or P0717.
No TCC Stuck ON DTC P0742.
No Shift Solenoid Electrical DTC P0753 or P0758.
No Transmission Component Slipping DTC P0894.
No TFP manual valve position switch DTC P1810.
No TCC solenoid valve DTC P2761.
The system voltage is 10-18 volts for greater than 0.5 second.
Not in 4WD Low.
The transmission OSS is greater than 7 RPM.
Transmission ISS is greater than 7 RPM.
The TP sensor is greater than 10 percent.
The engine torque must be between 108 N.m (80 lb ft) and:
- 6.0L: 576 N.m (425 lb ft)
- 8.1L: 881 N.m (650 lb ft)
No TFP manual valve position switch change within 6 seconds.
The TFP manual valve position switch indicates D4.
The transmission fluid temperature (TFT) is greater than 20°C (68°F) and less than 130°C (266°F).