Conditions for Clearing the MIL/DTC
WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
- A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
- Clear the MIL and the DTC with a scan tool.
DTC P0496
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Evaporative Emissions (EVAP) Hose Routing Diagram | ||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
-1 to +1 H2O | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 |
|
-1 to +1 H2O | Go to Step 4 | Go to Step 5 |
| 4 | Replace the EVAP purge solenoid valve. Refer to Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement
. Did you complete the replacement? |
- | Go to Step 6 | - |
| 5 | Replace the fuel tank pressure (FTP) sensor. Refer to Fuel Tank Pressure Sensor Replacement
. Did you complete the replacement? |
- | Go to Step 6 | - |
| 6 |
|
-1 to +1 H2O | Go to Step 7 | Go to Step 2 |
| 7 | Observe the Capture Info with a scan tool. Have any other DTCs not been diagnosed? |
- | Go to Diagnostic Trouble Code (DTC) List - Vehicle | System OK |