Test Description
WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
The number below refers to the step number on the diagnostic table.
- 3: Sealing the system will allow normal pressure in the EVAP System to preload the sensor. This will help put the sensor in a range that is more sensitive, making the test more accurate.
DTC P0454
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Evaporative Emissions (EVAP) Hose Routing Diagram
and Engine Controls Schematics Connector End View Reference: Powertrain Control Module (PCM) Connector End Views or Engine Controls Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Are DTCs P0442, P0446, P0452, P0453, or P0651 also set? | Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | Go to Step 3 |
| 3 | Inspect for an intermittent and for a poor connection at the fuel tank pressure (FTP) sensor. Refer to Testing for Intermittent Conditions and Poor Connections
in Wiring Systems. Did you find and correct the condition? |
Go to Step 5 | Go to Step 4 |
| 4 | Replace the FTP sensor. Refer to Fuel Tank Pressure Sensor Replacement
. Did you complete the replacement? |
Go to Step 5 | - |
| 5 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? |
Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | System OK |