LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 787 (Transfer Case - NVG 246-NP8 - Service & Diagnosis) >> Schematic and Routing Diagrams >> Transfer Case Control Schematic Icons

Transfer Case Control Schematic Icons

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 GMC Yukon, 2006 Chevrolet Tahoe, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Transfer Case Control Schematic Icons

Icon Icon Definition
GM296880Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Twisted-pair wires provide an effective shield that helps protect sensitive electronic components from electrical interference. Depending on application, twisted-pair wires are used on wiring harnesses connecting the following components:
  • The electronic ignition (EI) control module
  • The manifold absolute pressure (MAP) sensor
  • The powertrain control module (PCM)
  • The vehicle speed sensor (VSS)

In order to prevent electrical interference from degrading the performance of the connected components, you must maintain the proper specification when making any repairs to the twisted-pair wires shown :
  • The wires must be twisted a minimum of 9 turns per 30.5 cm (12 in) as measured anywhere along the length of the wires.
  • The outside diameter of the twisted wires must not exceed 6.0 mm (0.236 in).
Refer to Splicing Twisted or Shielded Cable in Wiring Systems.
scientia non olet · About LEMON Manuals