LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 787 (Transfer Case - NVG 246-NP8 - Service & Diagnosis) >> Repair Instructions >> Transfer Case Shift Control Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 GMC Yukon, 2006 Chevrolet Tahoe, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting Selector Switch Electrical Connectors
    GM830158Courtesy of GENERAL MOTORS CORP.
  1. Remove the instrument panel (I/P) cluster bezel. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster in Instrument Panel, Gages, and Console.
  2. Using a flat-tipped screwdriver, gently pry the retaining clips open on the housing.
  3. Slide out the selector switch until the electrical connectors are accessible.
  4. Disconnect the selector switch electrical connectors (2, 3).
    5. Fig 2: Removing Selector Switch From Housing
    GM396838Courtesy of GENERAL MOTORS CORP.
  5. Remove the selector switch from the housing.
scientia non olet · About LEMON Manuals