LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 787 (Transfer Case - NVG 246-NP8 - Service & Diagnosis) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 GMC Yukon, 2006 Chevrolet Tahoe, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rear Output Shaft Bushing
    GM801307Courtesy of GENERAL MOTORS CORP.
  1. Using the J 45380  , install a NEW output shaft bushing. See Special Tools .
    1. Install the bushing or the finger section of the J 45380  . See Special Tools .
    2. Install the finger section to the main body of the J 45380  . See Special Tools .
    3. Position the bushing and tool to the case.
    4. Using a hammer and the J 45380  , install the bushing. See Special Tools .
    2. Fig 2: Installing Output Shaft Seal
    GM687288Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the drain hole on the boot of the rear output shaft seal is facing down toward the ground.
  2. Using the J 37668-A  , install a NEW front output shaft seal. See Special Tools .
  3. Install the rear propeller shaft. Refer to Propeller Shaft Replacement - Rear in Propeller Shaft.
  4. Check the fluid level. Add fluid if necessary.
  5. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
scientia non olet · About LEMON Manuals