LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 786 (Engine Mechanical - 8.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When installing the oil pump, always replace the retainer between the oil pump and the shaft.
    Fig 1: View Of Crankshaft Oil Deflector
    GM843909Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the crankshaft oil deflector.
  2. Install the crankshaft oil deflector nuts.

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

    3. Fig 2: View Of Oil Pump
    GM843907Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: During assembly, install NEW oil pump driveshaft retainer. Slightly heat the retainer above room temperature for ease of installation onto the oil pump driveshaft.
  3. Assemble the oil pump, driveshaft and a NEW retainer.
  4. Install the oil pump. Position the oil pump onto the locating pins.
  5. Install the oil pump bolt.

    Tighten:  Tighten the bolt to 75 N.m (56 lb ft).

  6. Install the oil pan. Refer to Oil Pan Replacement .
scientia non olet · About LEMON Manuals