LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 786 (Engine Mechanical - 8.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Pump Drive Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Drive
    GM843883Courtesy of GENERAL MOTORS CORP.
  1. Apply grease to the oil pump drive gear for ease of assembly.
    2. IMPORTANT: Correct alignment of the oil pump drive and oil pump driveshaft is critical. Make sure both components mate correctly, or engine damage may occur.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Line up the oil pump drive, making sure that the oil pump is fully seated in the engine block.
  3. Install the oil pump drive bolt, making sure that the oil pump drive is fully seated in the engine block.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  4. Install the intake manifold. Refer to Intake Manifold Replacement .
scientia non olet · About LEMON Manuals