Installation Procedure
WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install the sight shield bracket to the studs (2), if necessary.
- Install the sight shield bracket nuts (1), if necessary.
Tighten: Tighten the nuts to 5 N.m (44 lb in).
- Install the intake manifold sight shield to the bracket.
- Snap the intake manifold sight shield onto the stud.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
NOTE:
Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.