Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: "Engine Side" stamped on the flywheel is to be positioned toward the engine.

Fig 1: View Of Engine Flywheel & Bolt (Automatic)

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the flywheel.
Install the flywheel bolts.
Tighten:
1. Tighten the bolts a first pass to 40 N.m (30 lb ft).
2. Tighten the bolts a second pass to 80 N.m (59 lb ft).
3. Tighten the bolts a final pas to 100 N.m (74 lb ft).
Install the transmission. Refer to Transmission Replacement in Automatic Transmission - 4L80-E.