LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 786 (Engine Mechanical - 8.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • The balancer should be positioned onto the end of the crankshaft as straight as possible prior to tool installation.
  • Apply grease or clean engine oil to the inside of the crankshaft balancer or the end of the crankshaft, to prevent galling during assembly.
    Fig 1: Installing Crankshaft Balancer Using J 42845
    GM639539Courtesy of GENERAL MOTORS CORP.
  1. Install the balancer onto the end of the crankshaft.
  2. Install J 42845  to the crankshaft balancer. See Special Tools .
    IMPORTANT: Apply the lubricant that comes with J 42845  each time the tool is used. See Special Tools . Failure to lubricate the J 42845  may prevent the balancer from installing completely. See Special Tools .
  3. Using J 42845  install the balancer. See Special Tools .
  4. Tighten the J 42845  until the crankshaft balancer is completely seated against the crankshaft sprocket. See Special Tools .
    5. Fig 2: View Of J 42845
    GM639542Courtesy of GENERAL MOTORS CORP.
  5. Remove the J 42845  from the crankshaft. See Special Tools .
    6. Fig 3: View Of Crankshaft Balancer Bolt & Washer
    GM470799Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the crankshaft bolt and washer to the crankshaft.

    Tighten:  Tighten the bolt to 255 N.m (189 lb ft).

  7. Remove the J 42847  . See Special Tools .
  8. Install the starter motor. Refer to Starter Motor Replacement (8.1L Engine) in Engine Electrical.
  9. Install the fan. Refer to Fan Replacement in Engine Cooling.
  10. Install the A/C belt. Refer to Drive Belt Replacement - Air Conditioning .
scientia non olet · About LEMON Manuals