LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 786 (Engine Mechanical - 8.1L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Intake Manifold Disassemble

Intake Manifold Disassemble

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vacuum Plug
    GM1310056Courtesy of GENERAL MOTORS CORP.
  1. Remove the vacuum plug (513).
    2. Fig 2: View Of Throttle Body, Nuts, Studs & Gasket
    GM1310037Courtesy of GENERAL MOTORS CORP.
  2. Remove the throttle body nuts (503).
  3. Remove the throttle body (502) and gasket (501).
  4. Discard the gasket.
  5. Remove the throttle body studs (504), if required.
    6. Fig 3: View Of Oil Fill Tube & Components
    GM1310034Courtesy of GENERAL MOTORS CORP.
  6. Remove the oil fill cap (418).
  7. Remove the oil fill tube (416) and bolt (419).
    8. Fig 4: View Of MAP Sensor & Grommet
    GM471023Courtesy of GENERAL MOTORS CORP.
  8. Remove the manifold absolute pressure (MAP) sensor bolt and MAP sensor.
  9. Inspect the MAP sensor grommet for damage.
    10. Fig 5: View Of EVAP Tube
    GM471013Courtesy of GENERAL MOTORS CORP.
  10. Remove the evaporative emission (EVAP) tube.
    11. Fig 6: View Of EVAP Purge Valve & Bolt
    GM471015Courtesy of GENERAL MOTORS CORP.
  11. Remove the EVAP canister purge solenoid valve and bolt.
  12. Inspect the O-ring seal for damage. Replace as needed.
scientia non olet · About LEMON Manuals