LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 786 (Engine Mechanical - 8.1L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Front Cover Removal

Engine Front Cover Removal

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of CMP Sensor
    GM470803Courtesy of GENERAL MOTORS CORP.
    NOTE: This component is initially installed using a self-tapping bolt(s). Care should be taken when removing and/or installing the self-tapping bolt(s). Failure to use care when removing and/or installing the self-tapping bolt(s) can lead to damage and unnecessary replacement of the self-tapping bolt(s) and/or the component the self-tapping bolt(s) is threaded into.
  1. Remove the camshaft position (CMP) sensor bolt.
  2. Remove the CMP sensor.
  3. Inspect the CMP sensor O-ring for cuts, cracks, tears or damage. Replace the O-ring as required.
    4. Fig 2: View Of Engine Front Cover & Components
    GM1309997Courtesy of GENERAL MOTORS CORP.
  4. Remove the engine front cover bolts (521).
  5. Remove the engine front cover (522).
    6. IMPORTANT: The engine front cover gasket is reusable.
  6. Remove the engine front cover gasket (523).
  7. Remove the crankshaft front oil seal (125) from the engine front cover.
scientia non olet · About LEMON Manuals