LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 784 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Transmission Fluid Cooler Hose/Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Transmission Cooler Hoses From The Cooler
    GM396817Courtesy of GENERAL MOTORS CORP.
  1. Remove the grille assembly. Refer to Grille Replacement (Cadillac) or Grille Replacement (Avalanche) or Grille Replacement (Chevrolet) or Grille Replacement (GMC) in Exterior Trim.
  2. Remove the transmission fluid cooler hose from the Auxiliary oil cooler. Refer to Transmission Fluid Cooler Line Quick Connect Fitting
    3. Fig 2: Removing The Transmission Fluid Cooler Hose From The Radiator
    GM396808Courtesy of GENERAL MOTORS CORP.
  3. Remove the transmission fluid cooler hose from the radiator. Refer to Transmission Fluid Cooler Line Quick Connect Fitting
    4. Fig 3: Removing The Transmission Fluid Cooler Hoses From The Transmission
    GM396807Courtesy of GENERAL MOTORS CORP.
  4. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Remove the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  6. Remove the transmission fluid cooler hoses from the transmission. Refer to Transmission Fluid Cooler Line Quick Connect Fitting
  7. Remove the transmission fluid cooler hoses from the retainer on the engine.
  8. Remove the transmission fluid cooler hoses from the vehicle.
scientia non olet · About LEMON Manuals