LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 784 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Transmission Fluid Cooler Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing The Transmission Fluid Cooler Hoses From The Transmission
    GM396807Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission fluid cooler hoses to the vehicle.
  2. Install the transmission fluid cooler hoses to the transmission. Refer to Transmission Fluid Cooler Line Quick Connect Fitting
  3. Install the transmission fluid cooler hoses to the retainer on the engine.
  4. Install the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  5. Lower the vehicle.
    6. Fig 2: Removing The Transmission Fluid Cooler Hose From The Radiator
    GM396808Courtesy of GENERAL MOTORS CORP.
  6. Install the transmission fluid cooler hose to the radiator. Refer to Transmission Fluid Cooler Line Quick Connect Fitting
    7. Fig 3: Removing Transmission Cooler Hoses From The Cooler
    GM396817Courtesy of GENERAL MOTORS CORP.
  7. Install the transmission fluid cooler hose from the Auxiliary oil cooler. Refer to Transmission Fluid Cooler Line Quick Connect Fitting
  8. Install the grille assembly. Refer to Grille Replacement (Cadillac) or Grille Replacement (Avalanche) or Grille Replacement (Chevrolet) or Grille Replacement (GMC) in Exterior Trim.
scientia non olet · About LEMON Manuals