LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 784 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Reverse Servo Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Servo Assembly
    GM512992Courtesy of GENERAL MOTORS CORP.
  1. Remove the transmission filter. Refer to Automatic Transmission Fluid/Filter Replacement .
  2. Remove the rear servo from the transmission case in the following order:
    1. Cover bolts (6)
    2. Cover (5)
    3. Cover gasket (4)
    4. Bottom retaining clip (3)
    5. Servo piston (2)
    6. Outer ring oil seal (1)
    7. Inner ring oil seal (7)
    8. Accumulator piston (8)
    9. Piston seal (9)
    10. Washer (10)
    11. Servo spring (11)
    12. Servo spring retainer (12)
    13. Selective pin (13)
    14. Accumulator spring (14)