LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 784 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Reverse Servo Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Servo Assembly
    GM512992Courtesy of GENERAL MOTORS CORP.
  1. Install the rear servo to the transmission in the following order:
    1. Accumulator spring (14)
    2. Selective pin (13)
    3. Servo spring retainer (12)
    4. Servo spring (11)
    5. Washer (10)
    6. Piston seal (9)
    7. Accumulator piston (8)
    8. Inner ring oil seal (7)
    9. Outer ring oil seal (1)
    10. Servo piston (2)
    11. Bottom retaining clip (3)
    12. Cover gasket (4)
    13. Cover (5)
    14. Cover bolts (6)
      NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the cover bolts (61).

    Tighten:  Tighten the bolts to 24 N.m (18 lb ft).

  3. Install the transmission filter. Refer to Automatic Transmission Fluid/Filter Replacement .
scientia non olet · About LEMON Manuals