LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 784 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Park/Neutral Position Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting The Park/Neutral Position (PNP) Switch Electrical Connector
    GM1284299Courtesy of GENERAL MOTORS CORP.
  1. Apply the park brake.
  2. Shift the transmission into neutral.
  3. If equipped with 4-wheel drive (4WD), remove the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Disconnect the park/neutral position (PNP) switch electrical connector (2).
    6. Fig 2: View Of Range Selector Cable End At Transmission Range Selector Lever Ball Stud
    GM738167Courtesy of GENERAL MOTORS CORP.
  6. Remove the range selector cable end (2) from the range selector lever ball stud (1).
    7. Fig 3: Removing The Control Lever From The Manual Shaft
    GM1480478Courtesy of GENERAL MOTORS CORP.
  7. Remove the control lever to the manual shaft nut.
  8. Remove the control lever from the manual shaft.
  9. Remove the PNP switch bolts.
  10. Remove the PNP switch from the manual shaft. If the PNP switch does not slide off the manual shaft, file the outer edge of the manual shaft in order to remove any burrs.
scientia non olet · About LEMON Manuals