LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 784 (Automatic Transmission - 4L80-E/4L85-E - Introduction (2 Of 2)) >> Repair Instructions >> Input Shaft Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Input & Output Speed Sensors
    GM686957Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the input speed sensor seal with automatic transmission fluid.
  2. Install the input speed sensor (1).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the input speed sensor bolt.

    Tighten:  Tighten the bolt to 11 N.m (96 lb in).

    4. Fig 2: Disconnecting The Input Speed Sensor Electrical Connector
    GM859361Courtesy of GENERAL MOTORS CORP.
  4. Connect the input speed sensor electrical connector (1).
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals