LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Throttle Actuator Control (TAC) Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: I/P Wiring Harness Electrical Connector
    GM858196Courtesy of GENERAL MOTORS CORP.
  1. Remove the connector position assurance (CPA) retainer (1).
  2. Disconnect the instrument panel (I/P) wiring harness electrical connector (2).
    3. Fig 2: View Of TAC Module Electrical Connector
    GM871922Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the engine wiring harness electrical connector (1).
    4. Fig 3: Throttle Actuator Control (TAC) Module Nuts
    GM855736Courtesy of GENERAL MOTORS CORP.
  4. Remove the throttle actuator control (TAC) module nuts.
  5. Remove the TAC module.
scientia non olet · About LEMON Manuals