Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Throttle Actuator Control (TAC) Module Nuts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the TAC module.
Install the TAC module nuts.
Tighten: Tighten the nuts to 9 N.m (80 lb in).

Fig 2: View Of TAC Module Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the engine wiring harness electrical connector (1).

Fig 3: I/P Wiring Harness Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the I/P wiring harness electrical connector (2).
Install the CPA retainer (1).