LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Ignition Coil, ECT And MAP Sensor Electrical Connectors
    GM750529Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical - 8.1L.
  2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (1).
    3. Fig 2: MAP Sensor And Mounting Bolt
    GM858207Courtesy of GENERAL MOTORS CORP.
  3. Remove the MAP sensor bolt.
  4. Remove the MAP sensor.
  5. Inspect the MAP sensor seal for wear or damage, replace as necessary.
scientia non olet · About LEMON Manuals