LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Pressure Sensor
    GM1312086Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the seal on the fuel pressure sensor.
  2. Press the fuel pressure sensor (1) into the line.
  3. Install the intermediate fuel/EVAP lines. Refer to Fuel Hose/Pipes Assembly Replacement (Front)  or Fuel Hose/Pipes Assembly Replacement (Intermediate) .
scientia non olet · About LEMON Manuals