LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement (Rear Tank) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Level Sensor (Rear Tank)
    GM1332910Courtesy of GENERAL MOTORS CORP.
  1. Remove the sending unit. Refer to Fuel Sender Assembly Replacement (Front Tank)  or Fuel Sender Assembly Replacement (Rear Tank) .
  2. Disconnect the level sensor electrical connector.
  3. Release the level sensor retaining clip.
  4. Squeeze the locking tangs together, and remove the fuel level sensor (1).
scientia non olet · About LEMON Manuals