LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Tube From At Fuel Rail
    GM843918Courtesy of GENERAL MOTORS CORP.
  1. Connect the EVAP purge tube at the EVAP pipe.
  2. Connect the EVAP purge tube clip to the fuel rail bracket.
    3. Fig 2: View Of EVAP Purge Tube At Purge Solenoid
    GM843915Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP purge tube at the purge solenoid.
    4. Fig 3: View Of Generator, Injector Harness, Ignition Coil Harness, ETC & Purge Valve Solenoid Electrical Connectors
    GM1235689Courtesy of GENERAL MOTORS CORP.
  4. Connect the fuel injector harness electrical connector (3).
  5. Install the engine sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical - 8.1L.
scientia non olet · About LEMON Manuals