LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Canister/Fuel Tank >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Lines
    GM1312085Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP lines (1) to the retaining clips.
    2. Fig 2: View Of EVAP Lines At Fuel Tank Module (Rear Tank)
    GM1372819Courtesy of GENERAL MOTORS CORP.
  2. Remove the caps from the EVAP openings.
  3. Connect the EVAP lines to the module. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Install the rear fuel tank. Refer to Fuel Tank Replacement (Front Tank)  or Fuel Tank Replacement (Rear Tank) .
scientia non olet · About LEMON Manuals