LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting, in order to avoid possible EVAP system contamination.
    Fig 1: View Of EVAP CVS Electrical Connector & CVS Bracket
    GM1224403Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the EVAP canister vent solenoid (CVS) electrical connector (1).
  3. Disconnect the CVS quick connect fitting at the canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  4. Disengage the retaining tab on the CVS bracket (2).
  5. Remove the CVS and line.
  6. If necessary, disconnect and remove the CVS line. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
scientia non olet · About LEMON Manuals