LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Clean all evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting, in order to avoid possible EVAP system contamination.
    Fig 1: View Of EVAP CVS Electrical Connector & CVS Bracket
    GM1224403Courtesy of GENERAL MOTORS CORP.
  1. Remove the right side, rear bumper step pad. Refer to Step Pad Replacement - Top Rear Bumper in Bumpers.
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Disconnect the EVAP canister vent solenoid (CVS) electrical connector (1).
    4. Fig 2: View Of EVAP Canister & Quick Connect Fittings
    GM1372543Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the EVAP canister quick connect lines. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  5. Remove the EVAP canister bolt.
  6. Lower the vehicle half way.
    7. Fig 3: View Of EVAP Canister Bracket Nuts
    GM1373032Courtesy of GENERAL MOTORS CORP.
  7. Loosen the EVAP canister bracket nuts (1).
    8. Fig 4: View Of Front Bracket Clip
    GM1372958Courtesy of GENERAL MOTORS CORP.
  8. Using a flat bladed screwdriver, disengage the front bracket clip.
    9. Fig 5: View Of Rear Bracket Clip
    GM1372960Courtesy of GENERAL MOTORS CORP.
  9. Using a flat bladed screwdriver, disengage the rear bracket clip.
  10. Remove the EVAP canister.
  11. Cap the EVAP lines in order to prevent possible EVAP system contamination.
scientia non olet · About LEMON Manuals