LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Bracket Clip
    GM1372960Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the EVAP lines.
  2. Install the EVAP canister.
  3. Using a flat bladed screwdriver, engage the rear bracket clip.
    4. Fig 2: View Of Front Bracket Clip
    GM1372958Courtesy of GENERAL MOTORS CORP.
  4. Using a flat bladed screwdriver, engage the front bracket clip.
    5. Fig 3: View Of EVAP Canister Bracket Nuts
    GM1373032Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Tighten the EVAP canister bracket nuts (1).

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

    6. Fig 4: View Of EVAP Canister & Quick Connect Fittings
    GM1372543Courtesy of GENERAL MOTORS CORP.
  6. Raise the vehicle.
  7. Install the EVAP canister bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  8. Connect the EVAP canister quick connecting lines. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    9. Fig 5: View Of EVAP CVS Electrical Connector & CVS Bracket
    GM1224403Courtesy of GENERAL MOTORS CORP.
  9. Connect the EVAP CVS electrical connector (1).
  10. Lower the vehicle.
  11. Install the right side, rear bumper step pad. Refer to Step Pad Replacement - Top Rear Bumper in Bumpers.
scientia non olet · About LEMON Manuals