LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator, Injector Harness, Ignition Coil Harness, ETC & Purge Valve Solenoid Electrical Connectors
    GM1235689Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical - 8.1L.
  2. Disconnect the evaporative emission (EVAP) canister purge valve electrical connector (1).
    3. Fig 2: View Of EVAP Purge Tube At Purge Solenoid
    GM843915Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the EVAP purge tube from the purge solenoid.
    4. Fig 3: EVAP Purge Tube Connector
    GM695582Courtesy of GENERAL MOTORS CORP.
  4. In order to disconnect the EVAP purge tube connector (1), slide the retaining tab (2) to the release position and separate the connection.
    5. Fig 4: EVAP Canister Purge
    GM858210Courtesy of GENERAL MOTORS CORP.
  5. Remove the EVAP canister purge valve bolt.
  6. Remove the EVAP canister purge valve.
scientia non olet · About LEMON Manuals