Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: EVAP Canister Purge

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the EVAP canister purge valve.
Install the EVAP canister purge valve bolt.
Tighten: Tighten the bolt to 10 N.m (89 lb in).

Fig 2: View Of EVAP Purge Tube At Purge Solenoid

Courtesy of GENERAL MOTORS CORP.

Connect the EVAP purge tube to the purge solenoid.

Fig 3: View Of Generator, Injector Harness, Ignition Coil Harness, ETC & Purge Valve Solenoid Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the EVAP canister purge valve electrical connector (1).
Install the engine sight shield. Refer to Engine Sight Shield Replacement in Engine Mechanical - 8.1L.