LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Protection Shield
    GM349061Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the engine shield bolts and shield, if equipped.
    3. Fig 2: View Of CMP Sensor Electrical Connector Battery Cable Channel Engine Harness Clips
    GM750902Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the camshaft position (CMP) sensor electrical connector (1).
    4. Fig 3: CMP Sensor And Bolt
    GM858218Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP sensor bolt.
  5. Remove the CMP sensor.
  6. Inspect the CMP sensor for wear, cracks or leakage if the sensor is not being replaced.
scientia non olet · About LEMON Manuals