LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal with Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.
    Fig 1: APP Sensor Electrical Connector
    GM1657866Courtesy of GENERAL MOTORS CORP.
  1. Remove the connector position assurance (CPA) retainer.
  2. Disconnect the accelerator pedal position (APP) sensor electrical connector (1).
    3. Fig 2: Accelerator Pedal Bolts
    GM1657867Courtesy of GENERAL MOTORS CORP.
  3. Remove the accelerator pedal bolts.
  4. Remove the accelerator pedal.
scientia non olet · About LEMON Manuals