LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2006 >> Escalade AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 783 (Engine Control System - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal with Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Yukon XL, 2006 Chevrolet Suburban, and 2006 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Accelerator Pedal Bolts
    GM1657867Courtesy of GENERAL MOTORS CORP.
  1. Position the accelerator pedal to the accelerator pedal bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the accelerator pedal bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    3. Fig 2: APP Sensor Electrical Connector
    GM1657866Courtesy of GENERAL MOTORS CORP.
  3. Connect the APP sensor electrical connector (1).
  4. Install the CPA retainer.
  5. Connect a scan tool to the diagnostic port in order to test for proper throttle-opening and throttle-closing range.
  6. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle, and a wide open throttle (WOT).
  7. Verify that the vehicle meets the following conditions:
    • The vehicle is not in a reduced engine power mode.
    • The ignition is ON.
    • The engine is OFF.
  8. Inspect the carpet fit under the accelerator pedal.
scientia non olet · About LEMON Manuals